Please choose right part number as following guide line as below.
| ① Motor Size |
|
||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ② Linear Actuator Type |
E = External Linear Actuator N = Non-Captive Linear Actuator C = Electric Cylinder (Captive) Linear Actuator K = Kaptive Linear Actuator |
||||||||||||||||||
| ③ Motor Step Angle |
2 = 2-phase, 1.8° step angle 4 = 2-phase, 0.9° step angle 5 = 5-phase, 0.72° step angle |
||||||||||||||||||
| ④ Motor Length |
1 = Single Stack 2 = Double Stack 3 = Triple Stack |
||||||||||||||||||
| ⑤ Rated Current / Phase | XX = X.X [A]/Phase | ||||||||||||||||||
| ⑥ Lead Screw Code | Please refer to lead screw code selection table | ||||||||||||||||||
| ⑦ Number of Lead Wires | 4 = 4-wire leads 6 = 6-wire leads 8 = 8-wire leads |
||||||||||||||||||
| ⑧ Lead Screw Length / Stroke | XXX = XXXmm Lead Screw Length [For External Linear/Non-Captive type] XXX = X.XX inch Stroke [For Electric Cylinder(Captive) / Kaptive type] *Captive/Kaptive: standard strokes by motor size. |
||||||||||||||||||
| ⑨ Lead Screw Surface Treatment |
T = Teflon Coating S = Standard (No Teflon Coating) K = Electroplated Teflon Coating C = Customization * Surface treatment depends on lead and application. |
||||||||||||||||||
| ⑩ End Machining |
M = Metric U = UNC S = Smooth C = Customization [Please provide the required customization specifications.] N = None |
||||||||||||||||||
| ⑪ Nut Style |
S = Standard Flange Nut [For External] A = Anti-Backlash Nut [For External / Non-Captive type] C = Customization |
||||||||||||||||||
| ⑫ Option |
EKX = Encoder (X = Encoder Resolution) P = Manual Knob B = Brake X = Rear Shaft R = Encoder Ready C = Customization N = No rear-end machining |
||||||||||||||||||
| ⑬ Customer Sequence Number | |||||||||||||||||||
| Example |
|
